This was made using the promotional Promise Of Spring project pack paper & the Promise Of Spring stamp set.
ITEM NO Z9012 - Promise Of Spring project pack papers
ITEM NO E1005A - Promise Of Spring stamp set
ITEM NO Z2147 Smokey Plum Ink Pad
ITEM NO Z2103 Bamboo Ink Pad
ITEM NO Z534 Micro Tip Scissors
ITEM NO Z268 3-D Foam Squares
ITEM NO 1514 Tombow Adhesive Runner
Instructions
- I started with a standard sized 4 1/4" x 5 1/2" card (you can get this by cutting an 11 x 8.5" CS in half, then folding one of the cut pieces in half)
- I chose 4 different papers from the POS project pack & cut a rectangle 2 1/8 x 2 3/4" from each of them.
- Adhere the 4 rectangles of paper to the card using the Tombow Adhesive.
- Stamp the Large flower petal design from the stamp set onto Colonial White CS (also found in the POS project pack) using Smokey Plum ink. Then cut around the edge of it carefully using the microtip scissors. DO NOT cut out the center of the flower.
- Stamp the circle stamp for the center of the flower using bamboo ink also on Colonial White CS & then cut around the edge of it carefully.
- Stamp the final lines in the middle of the circle using the stamp & smokey purple ink, directly onto the stamped & cut out bamboo circle.
- Stick the flower petals to the card using 4 3D foam squares. Position it as close to the center as you can.
- Stick the circle middle of the flower on top of the flower base using 3 or 4 more 3D foam squares.
You are now finished & can write or stamp a sentiment inside the card.
|